AIRGUN TACTICAL DEFENDER 3 (AGT D3) MINI
These are all CUSTOM BUILT per order. Due to the custom cut barrels that does add come additional cost over the standard long barrel version. But the size of this is on par with a small 9mm Glock! Once you place your order, we build them and ship them out within an estimated 3 weeks.
We take an existing BinTac AEA Defender 2 and upgrade it to make it an all black reinforced frame and receiver, enhanced front and rear fiber optic sights. We included on the lower side of the barrel a picatinny rail for a red dot or tactical light. Short two finger honeycomb grip. We have modified the receiver recessing firing ping which prevents them from breaking like the original Defender 2 models after too much use. We have a modified built in trigger pull safety eliminating the safety switch so in the event of an emergency you have faster reaction time!
Specs
- Semi Automatic Pre-charged pneumatic (PCP) air pistol.
- .35 CAL 81 Grain - 61.01 Joules / 45 Foot Pounds Energy (FPE)
- Max. Muzzle Velocity 490 FPS because of the higher velocity these have deeper penetration than the .457 Cal!
- .45 CAL 155 Grain - 67.79 Joules / 50 Foot Pounds Energy (FPE)
- Max. Muzzle Velocity 360 FPS
- Big Bore Pistol in .357 / .457 Cal
- 3.7CC cartridge capacity
- MAX fill pressure 4200 PSI
- Sights: Fiber Optic
- Rail: Picatinny Lower Rail for (Red Dot or Light Combo)
- Length: 7.25 in. and from the handle it's 8.75 in.
- Barrel Length 2 in.
- Weight: Under 1 pound
- Trigger Safety: The mechanical design is classified as Semi-Auto but it's similar to a (DOA ) double action only revolver.
- Trigger Pull: 7 pounds.
- One (1) Year Limited AirGun Tactical Warranty.
Frame & Receiver Specs
- Material Used: (same stuff all the firearms guys use) PLA+ high temp ratings and is extremely strong rock solid but under stress it can flex a little whereas other material would just snap under stress
- All internals including the barrels are BinTac AEA Defender 2's
- You must use certified ammo on this pistol to prevent from having issues
AGT D3 CERTIFIED .356 9MM AMMO
ADT D3 CERTIFIED .457 AMMO
NOTE: AEA BinTac Defender 2 frame is approximately 2mm and even less in some areas like the lock, etc. The AirGun Tactical D3 is .4 inch at the strong points, a massive difference! The AGT D3 model looks a million times better and is way stronger. The best part it's not sun bleached SCHOOL BUS YELLOW!
Accessories included:
- 2 Barrels with Rifling
- 2 Cartridges
- 2 Trigger Safety Blocks
- 100 Burst Discs
- 1 Fill Adapter
- Rubber Grip Included!
- Conceal Carry Holster (NOT INCLUDED)
Red Dot Light and Holster NOT Included!
AGT D3 CERTIFIED .356 9MM AMMO
ADT D3 CERTIFIED .457 AMMO
PRE-CHARGING YOUR DEFENDER CARTRIGES: The Defender Cartridges have a replaceable rubber seal and may loose pressure over a period of months or years. However we have tested their ability to hold pressure over a two year period of time and about half of them held full pressure over this two year period of time!
Warning
- Must be 18 and over to purchase airguns.
- Please check local and state laws.
- Never point airguns at a person or any living thing.
- Airguns can cause serious injury or death.
- Review the manual prior to initial use.
- Using uncertified ammo will void out your warranty.
High Quality Precision Semi-Automatic Airguns
